Thanks Guys !

Hi Mike here they are.This is what you need to rebuild your Crossovers.

Capacitors
a) 21uF , so you will need a 12uFand a 9uf
b) 16 uF, so you will need 2 8uF's
c) 8 uF
d) 6 uF

I used Solen 400v DC

Resistors if out of spec.
a) 3.9 ohm 10 watt 2% audio grade 2 will be needed.
b) 3.0 ohm 10 watt 2% audio grade 1 will be needed.
c) 2.0 ohm " " " " " 1 will be needed

DO NOT replace the (Coils-Inductors) they are part of the voicing and very rarely go bad ! Only if they are bad should you replace.Of Course.


The L-pads should be cleaned thoroughly with De-oxit or can be replaced if needed but they should be OK with a cleaning you should be able to tell by checking while using them if cleaning would be enough.

Replace all wires with new 14 awg minimum. 12 awg would be better.
You will be completely floored when you hear the difference if your Crossovers are original.And most important bypass the ground lugs with ground wire so you have direct wire grounds.I have a picture in the album showing where the bypass should be made.:2thumbsup:

You need anything else let me know Regards ~ John

Model 19 Modifications pictures by Altec_Best - Photobucket